Studiobot XL Quick Start Guide
34
Studiobot XL Quick Start Guide
Appendix
2
Studiobot XL panels
Studiobot base panel connector summary
1.
TALLY LIGHT
connector is the power in connector for teleprompter.
2-4.
ETHERNET
connectors. The
CAMERA
connector providesEthernett
communication with the camera and the
LENS
connector is to
communicate with the lens.
SERVICE
connector is an additional
port to be used by MRMC support and has the IP 192.168.37.165.
CAMERA
port is rated at 100 Mbits/sec.
5.
ROBOT ONLY
Ethercat connector. You use this to connect the cifX
board in the Stäubli CS8 unit (inside the Studiobot base) to the cifX
board in the Robocam Atelier PC, via the umbilical cable. The cifX
Ethernet network is an industrial grade high speed network used to
control the Studiobot motion, and is completely separate from the
Ethernet network that runs the camera and lens.
6.
PENDANT
connector, for attaching a Teach Pendant to the rig. This
is required for the rig to operate, and should only be removed under
advice from MRMC support staff.
7,8,9.
VIDEO 1-3
connectors for the video signal from the camera or to
the Teleprompter.
10.
E STOP
connector. You connect this to the E-stop button or
Broadcast Panel beside the computer stack, via the umbilical cable.
4
3
2
1
5
9
8
7
6
10
Summary of Contents for MRMC-2011-01
