LambdaDriver 400 & 800
ML46430, Rev. 07
October 2004
Chapter 3
Installation
General
This chapter describes the requirements and detailed step-by-step procedure for installing the
LDx00 and its components (modules and chassis).
Safety
Before installing the LDx00, ensure that the safety requirements noted in the chapter Safety
Requirements are met.
Package Contents
Essentials
1. Chassis (as many as ordered by the customer)
2. Mux
module (1 per chassis) and Demux Module
or
OADM modules (up to two per chassis – as many as ordered by the customer)
3. Transponder modules (1 to 8 per chassis – as many as ordered by the customer)
(A transponder module is essential in all cases except if only ESCON and GM2 modules
are to be used to operate in outband mode or medium-range inband mode. Details are
given in the section
and the section
4. Power Supply module (1 or 2 per chassis)
5. Power Cord (1 per power supply)
6. Jumper Fiberoptic Cables kit
7. User Manual on CD (1)
8. Release Notes (1) – if provided
Options
1. Management module (1 per chassis)
2. 1+1 Protection module (1 per chassis)
3. Service module (1 per chassis)
4. ESCON Multiplexer module (as many as ordered by the customer)
5. GM2 Gigabit Ethernet Multiplexer module (as many as ordered by the customer)
6. OA module (as many as ordered by the customer)
7. Redundant Power Supply module (1 per chassis)
8. Power cord for backup power supply (1 per power supply)
9. Y-cables for exclusive end-to-end redundancy topologies (one per transponder)
(Details are given in
Appendix I: Redundancy Protection Networks
.)
Requirements
25
Muxes are not required for ring network configurations.
26
Demuxes are not required for ring and single-fiber point-to-point network configurations.
100
