9
MSA Tool Tethers with Carabiners
US
If there is no attachment point on the tool, the loop end of a Detachable Loop (for tools 5 lbs and
under) can be securely wrapped around and taped to the tool using Tool Tether Tape
(P/N 1020138).
1. Measure the diameter of the tool shaft. Use the tool weight and shaft diameter in the following
table to determine the appropriate tool tether and length of tape piece needed.
2. Place the handle of the tool on top of the
loop on the loop end of the tether (web
end side down).
3. Guide the opposite end of the tether
including the side release buckle
through the loop.
4. Pull tight and adjust the slide lock to
snugly secure the loop around the tool.
Summary of Contents for 10207284
Page 6: ...6 MSA Tool Tethers with Carabiners US Fig 1 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 ...
Page 18: ...6 Longes pour outils MSA avec mousquetons CA Fig 1 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 ...
Page 30: ...6 Ataduras de herramientas MSA con mosquetones MX Fig 1 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 ...
Page 42: ...6 MSA Tool Tether Werkzeughaltegurte mit Karabiner DE Abb 1 Abb 2 Abb 3 Abb 4 Abb 5 Abb 6 ...
