Additional Information
FS-B35XX Series Start-up Guide
24
7.2
Specifications
FS-B35XX Series
3
Available Ports
2 x 10/100 BaseT Ethernet connectors (auto sensing) with ESD Protection:
N1,
N2
. Ethernet ports are not networked together.
2 x RJ45 RS-232 connectors:
P1, P2
– both galvanically isolated with ESD
protection.
1 x RJ45 RS-232 System port:
Sys
– For FieldServer diagnostic use only.
2 x RS-485 Serial connectors:
R1, R2
– both galvanically isolated with ESD
protection.
1 x LonWorks
®
connector.
Auxiliary Components:
2x USB Host (Type A) connectors which can be used
to update the Firmware and Configuration File, Linux Kernel and Flash File
system. The Node ID selectors and LonWorks
®
Service button are available for
those drivers requiring these features. See appropriate driver manual. For more
information refer to
“ENOTE – Loading Files using USB”
Fieldbus:
Fieldbus connectors available on selected gateways.
Power Requirements
24 VAC (+/- 10%) and 12-30 VDC, 12W
NOTE: USE COPPER CONDUCTORS ONLY
Approvals
CE Marked, CSA Certified: UL916 Standard and CSA @ 22.2, DNP 3.0 Tested,
FCC: Part 15, LonMark Certified, Modbus Tested, RoHS3 Compliant,
GOST-R Certified
Power Requirements
4
Multi-mode power adapter: 9-30VDC or 12-24VAC
Physical Dimensions
(WxDxH)
5
6.3 W x 5.4 D x 1.95 H inches (16 x 13.7 x 5 cm)
Weight
2.5 lbs. (1.5 Kg)
Operating Temp.
0
– 60°C (32 – 140°F)
Surge Suppression
EN61000-4-2 ESD EN61000-4-3 EMC EN61000-4-4 EFT
Humidity
10 - 90% RH (non-condensing)
Figure 15: Specifications
“This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
•
This device may not cause harmful interference
•
This device must accept any interference received, including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his expense. Modifications not expressly approved by FieldServer
could void the user's authority to operate
the equipment under FCC rules.”
3
Specifications subject to change without notice.
4
Excluding external power supply.
5
Excluding mounting tabs.
