(5)
Use four screws to fasten the wall brackets to the surface and apply a torque of
5 Nm (3 ft-lbf).
NOTE:
If no wall brackets are used, mount the device to the surface directly.
Use four appropriate screws and apply a torque of 5 Nm (3 ft-lbf).
(6)
Close housing lid by tightening the lid screws with a torque of 1.5 Nm (1 ft-lbf).
(7)
Close right joins.
(8)
Optional:
Loosen grounding clamp.
a) Insert grounding cable and re-tighten grounding clamp with a torque of 2 Nm
(1.5 ft-lbf).
MSA HUB
13
GB
3 Assembly and Installation
