ULTRA ELITE RESPONDER FACEPIECE
2. Assemble the
exhalation spring onto
the piston.
Note:
Ensure that the last coil is captured by the catch.
3. Install the piston.
4. Install the pneumatic
spring.
5. Install the pneumatic retainer by engaging the hook in
the slot and pressing the posts into the holes.
Installing the Component Housing
1. Slide the housing into the front of the facepiece.
a. Starting at the top (narrow end) of the housing,
work the housing into the groove.
Note:
Ensure that the
housing is captured
completely by the groove
and that the centerline
marks are aligned.
2. Insert the narrow end
of the housing ring
between the lower lens
ring and facepiece
housing.
3. Align the component
housing ring center
mark with the
facepiece centerline.
Lubricate with Snoop
(P/N 600920) as
needed.
4. Start at the narrow end
and work the housing
ring onto the facepiece.
a.Work down both
sides until the ring
completely captures
the facepiece rubber.
Lubricate with
Snoop (P/N 600920)
as needed.
12
TAL 012 (L) Rev. 1 - 10096395
Catch
