Manual ERS (Energy Recovery System)
MSF-Vathauer Polska Sp. z.o.o ul. Staszica 37 PL-64-600 Oborniki
Tel: 0048 503972873 E-mail
info@msf-technik.pl
www.msf-technik.pl
Page 5 of 23
1.4. Installation
The installation and cooling of the device must be in accordance with the provisions of the relevant
documentation.
The ERS must be protected from excessive strain. They are to handle only in a way, so that no
components are bent and / or isolating distances altered. The contact of electronic components and
terminals must be avoided.
The ERS contain electrostatic sensitive devices. These components can be easily destroyed by
improper handling. Built-in electrical components must not be destroyed (potential health hazard).
1.5. Electrical connection
When working on live equipment and / or systems, the applicable national accident prevention
regulations (for example, VGB 4) must be observed.
The electrical installation has to be done according to the valid directives (e.g. cable diameters, fuse
protection, ground wire connection). More detailed information is to be found in the documentation.
Compliance with the limits for the plant according to the EMC juridical directive is in responsibility of
the manufacturer of the plant. Information about the EMC-compatible installation like screening,
grounding, alignment of filters and lying of cables are to be found in the documentation of the other
components.
1.6. Operation
Plants with integrated frequency inverters or servo controller with ERS must be equipped, if applicable,
with additional observation and security installations according to the concerning valid security
directives, e.g. act on technical work equipment, accident prevention regulations etc. The
documentation of the manufacturer has to be regarded.
After disconnection of the frequency inverters or the Servo controller from the supply voltage, voltage
conducting device parts and cable conductors on the ERS must not be immediately touched because
of possibly charged condensers. Please regard the according notification signs at the frequency
Inverters. During operation, all covers must keep closed.
1.7. Maintenance and servicing
The documentation of the manufacturer has to be regarded