MSHELI TETRAS 280, Instruction Manual

Tools required for assembly

Safety notes

Where indicated use Thread lock MEDIUM

Operate the model in open areas with no people nearby.

Do NOT  operate  the  model  in  the  following places and  situations (or else  you  risk  severe accidents):

-in  places where children gather or people pass through

-in residential areas and parks

-indoors and in limited space

-in windy weather or when there is rain, snow, fog or other precipitation

If you do not observe these instructions you may be held liable for personal injury or property damage!

Always check  the R/C system prior  to operating your model. 

When the R/C system batteries get weaker,the operational range of the R/C system decreases.

Note that you may lose control of your model when operating it under such conditions.

Keep in mind that other people around you might also be operating a R/C model. 

Never use a frequency which someone else is using at the same time. 

Radio signals will be mixed and you will lose control of your model.

If the model shows irregular behavior, bring the model to a halt  immediately and disconnect the batteries. 

Investigate the reason and fix the problem. 

Do not operate  the model again as  long as the problem is not solved, as this may lead to further trouble 

and unforeseen accidents.

In order to prevent accidents and personal injury, be sure to observe the following:

Before flying the model, ensure that all screws are tightened. 

A  single  loose  screw may  cause  a major accident.

Replace all broken or defective parts with new ones, as damaged parts lead to crashes.

Never approach a spinning propeller. Keep at least 10 meters/yards away from a spinning propeller.

Do not touch the motor immediately after use. It may be hot enough to cause burns. 

Perform all necessary maintenance.

PRIOR TO ADJUSTING AND OPERATING YOUR MODEL, OBSERVE THE FOLLOWING

Operate the model only outdoors and out of people’s reach as the main rotor operates at high rpm!

While  adjusting,  stand  at  least  10 meters

Novice R/C pilots should always seek advice from experienced pilots to obtain hints with assembly 

and for pre-fight adjustments. 

Note that a badly assembled or insuffciently adjusted of model is a safety hazard!

In  the  beginning,  novice R/C  pilots  should always be assisted by an experienced pilot 

and never fly alone!

MSHeli Srl

Italy

Hexagon screw drivers : 1,5mm

2