3-19
BIOS Setup
Power Button Function
This feature sets the function of the power button. Settings are:
[Power Off]
The power button functions as normal power off button.
[Suspend]
W hen you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Available settings are:
[Off]
Leaves the computer in the power off state.
[On]
Leaves the computer in the power on state.
[Former-Sts]
Restores the system to the status before power failure
or interrupt occurred.
Wake Up Event Setup
Press <Enter> and the following sub-menu appears.
Resume S3 By PS/2 Keyboard, Resume S3 By PS/2 Mouse
These fields allow the activity of the PS/2 peripherals (keyboard and mouse) to
wake up the system from S3 sleep state. Settings: [Enabled], [Disabled].
Resume By PCI Device PM E#
W hen set to [Enabled], the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event).
Settings: [Enabled], [Disabled].
Resume By RTC Alarm
The field is used to enable or disable the feature of booting up the system on a
scheduled time/date. Settings: [Enabled], [Disabled].