5-6
MS-7125 ATX Mainboard
Completing the RAID BIOS Setup
1. After assigning your RAID array disks, press
F7.
The Clear disk data prompt
appears.
2. Press
Y
if you want to wipe out all the data from the RAID array, otherwise press
N
. You must choose
Yes
if the drives were previously used as RAID drives.
The
Array List
window appears, where you can review the RAID arrays that you
have set up.
3.
Use the arrow keys to select the array that you want to set up, then press
Enter.
The
Array Detail
window appears.
4.
If you want to mark this disk as empty and wipe out all its contents then press
C
.
5.
At the prompt, press
Y
to wipe out all the data, otherwise press
N
.
6. Press
Enter
again to go back to the previous window and then press
Ctrl-X
to
exit the RAID setup. Now that the RAID setup has been configured from the RAID
BIOS, the next step is to configure and load NVRAID drivers under Windows, as
explained in “Installing the NVIDIA RAID Software Under Windows” on p5-9.
