3-15
BIOS Setup
SDRAM Bank Interleave
This field selects 2-bank or 4-bank interleave for the installed SDRAM.
Disable the function if 16MB SDRAM is installed. Settings:
Disabled
,
2-Way
and
4-Way
.
SDRAM Burst Length
This setting allows you to set the size of Burst-Length for DRAM. Bursting
feature is a technique that DRAM itself predicts the address of the next memory
location to be accessed after the first address is accessed. To use the feature,
you need to define the burst length, which is the actual length of burst plus the
starting address and allows internal address counter to properly generate the
next memory location. The bigger the size, the faster the DRAM performance.
Settings:
4 QW
,
8 QW
.
SDRAM 1T Command
This setting controls the SDRAM command rate. Selecting
Enabled
allows
SDRAM signal controller to run at 1T (T=clock cycles) rate. Selecting
Dis-
abled
makes SDRAM signal controller run at 2T rate.
1T
is faster than
2T
.
Setting options:
Disabled, Enabled.
Fast Command
This item controls the internal timing of CPU. Selecting
Ultra
allows CPU to
handle data/instructions at the fastest speed.
Fast
enables CPU to handle at a
faster speed, while
Normal
let CPU handle them at the slowest rate.
AGP Timing Control
Press <Enter> and the following sub-menu appears.
