15
Chapter 3. Connect & Remove from PC
Connect MEGA VIEW 588 to Computer
1.
Press button to power on
MEGA VIEW 588
.
2.
Plug the mini end of the supplied USB cable to
MEGA VIEW 588
, and the
other end to your computer.
3.
Once
MEGA VIEW 588
is connected to your computer, it should be
detected by your computer operating system automatically. You will see the
following message showing on
MEGA VIEW 588
.
Note: For Windows 98SE users, a driver is required to activate MEGA VIEW
588 on your computer.
4.
After connection is initialized, your computer operating system will
recognize
MEGA VIEW 588
as a hard disk. Go to [Device Manager] by
clicking “Start”
→
“Setting”
→
“Control Panel”
→
“System”
→
“Hardware”, and look for [MEGA VIEW 588 USB Device] under [Disk
Drive] to check connection status. If the connection is failed, you will not
find [MEGA VIEW 588 USB Device]. Repeat step 2 to reconnect
MEGA
VIEW 588
to your computer.