Hardware Setup
2-7
Chapter 2
2-6
Power Supply
ATX 20-Pin Power Connector: ATX1
This connector allows you to connect to an ATX power supply. To con-
nect to th e ATX power s upply, make s ure th e plug s of th e power supply is
inserted in the proper orientation and the pins are alig ned. Then push down
the power su pply firmly into the con nector. The powe r connec tor supports
instant power on
function which means that system will boot up immediately
when the power supply connector is inserted on the board.
The mainboa rd supports ATX power supply for the power system. Be-
fore insertin g the power supply connec tor, always make sure th at all compo-
nents are installed properly to ensure that no damag e will be caused.
ATX 12V Power Connector: JPW1
This 12V power connecto r is used to provide power to the CPU.
DDR Module Combination
To e nable normal operation, at least one DIMM mod ule sho uld be in-
stalled on the motherboard. You may install memory modules in the following
combination:
JPW1
ATX1
1. Support 64 MB, 128MB, 256 MB & 512 MB technologies for x8 & x16 devices
2. Supported devices must have 4 banks.
Installing DDR Modules
1. The DDR DIMM module has only one notch on the center.
2. Ins ert the DDR module v ertically into the DDR DIMM slo t. Make su re the
notch is on the rig ht orientation.
3. The plastic clips a t sides of the DIMM slot will automatically close.
Volt
Front View
Rear View
ATX1 Pin Definition
JPW1 Pin Definition
