3 - 6
M S-7176 ATX M ainboard
Primary IDE Master
Press PgUp/<+> or PgDn/<-> to select [Manual], [None] or [Auto] type. Note that
the specifications of your drive must match with the drive table. The hard disk
will not work properly if you enter improper information for this category. If your
hard disk drive type is not matched or listed, you can use [Manual] to define your
own drive type manually.
If you select [Manual], related information is asked to be entered to the following
items. Enter the information directly from the keyboard. This information should
be provided in the documentation from your hard disk vendor or the system
manufacturer.
Access Mode
The settings are [CHS], [LBA], [Large], [Auto].
Capacity
The formatted size of the storage device.
Cylinder
Number of cylinders.
Head
Number of heads.
Precomp
Write precompensation.
Landing Zone
Cylinder location of the landing zone.
Sector
Number of sectors.
Drive A
This item allows you to set the type of the floppy drives installed. Available
options: [Disabled], [360 KB, 5
1/4
], [1.2 MB, 5
1/4
], [720 KB, 3
1/2
], [1.44 MB, 3
1/2
], [2.
88MB, 3
1/2
].
Halt On
The setting determines whether the system will stop if an error is detected at
boot. Available options are:
[All Errors]
The system stops when any error is detected.
[No Errors]
The system doesn
’
t stop for any detected error.
[All, But Keyboard]
The system doesn
’
t stop for a keyboard error.
[All, But Diskette]
The system doesn
’
t stop for a disk error.
[All, But Disk/Key] The system doesn
’
t stop for either a disk or a keyboard error.
System Informaion
Press <Enter> for the sub-menu of each item:
BIOS versin/CPU Type/CPU ID/uCode ID/CPU Frequency/Total Memory
T his item s hows the BIOS vers ion, CPU type, CPU ID, uCode ID,
Summary of Contents for MS-7176
