3-22
BIOS Setup
▍
MS-7602
BIOS Setup
▍
MS-7602
For CPU Voltage:
The value here s the offset for you to adjust/add based on the current CPU voltage.
Please read the real-tme CPU voltage n “CPU Vcore” n the “H/W montor” page. Please
note the based CPU Voltage wll vary dependng on the dfferent CPU you nstall.
For DRAM Voltage:
Accordng to the Inte CPU spec, DRAM Voltage settng 1.65V may damage the CPU
permanently. It s strongly recommended that you nstall the DRAM wth the voltage set-
tng below 1.65V. You can read the DRAM voltage n GreenPower Center.
Spread Spectrum
When the manboard’s clock generator pulses, the extreme values (spkes) of the pulses
create EMI (Electromagnetc Interference). The Spread Spectrum functon reduces the
EMI generated by modulatng the pulses so that the spkes of the pulses are reduced to
flatter curves. If you do not have any EMI problem, leave the settng at Dsabled for opt-
mal system stablty and performance. But f you are plagued by EMI, set to Enabled for
EMI reducton. Remember to dsable Spread Spectrum f you are overclockng because
even a slght jtter can ntroduce a temporary boost n clock speed whch may just cause
your overclocked processor to lock up.
Important
If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
Remember to dsable Spread Spectrum f you are overclockng because even a slght
jtter can ntroduce a temporary boost n clock speed whch may just cause your over-
clocked processor to lock up.
▶
•
•
•
Summary of Contents for MS-7602
Page 1: ... G41TM S01 series MS 7602 v1 x Mainboard G52 76021X4 ...
Page 10: ......
Page 16: ......
Page 92: ......