MSI MS-9887, User Manual

iv

Preface

▍

FCC-B Radio Frequency Interference Statement

This  equipment  has  been  tested  and 

found to comply with the limits for a Class 

B digital device, pursuant to Part 15 of the 

FCC  Rules.  These  limits  are  designed 

to provide  reasonable  protection against 

harmful interference in a residential installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the measures listed below.

Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected. 
Consult the dealer or an experienced radio/television technician for help.

Notice 1

The changes or modifications not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment.
Notice 2
Shielded  interface  cables  and A.C.  power  cord,  if  any,  must  be  used  in  order  to 

comply with the emission limits.

◯

◯

◯

◯

VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU.
This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: 

this device may not cause harmful interference, and 
this device must accept any interference received, including interference that 

may cause undesired operation.

1)
2)

Micro-Star International

MS-9887