Hardware Setup
MS-7668
Chapter 2
2-15
Hardware Setup
MS-7668
Chapter 2
Fan Power Connectors: CPUFAN, SYSFAN1, SYSFAN2
The fan power connectors support system cooling fan with +12V. When connecting the
wire to the connectors, always note that the red wire is the positive and should be con-
nected to the +12V; the black wire is Ground and should be connected to GND. If the
mainboard has a System Hardware Monitor chipset on-board, you must use a specially
designed fan with speed sensor to take advantage of the CPU fan control.
1.Gro
und
2.+1
2V
3.Se
nsor
1.Gro
und
2.+1
2V
3.Se
nsor
4.Co
ntrol
CPUFAN
SYSFAN1/ SYSFAN2
Important
Please refer to the recommended CPU fans at processor’s official website or consult
the vendors for proper CPU cooling fan.
CPUFAN supports fan control. You can install Overclocking Center utility that will
automatically control the CPU fan speed according to the actual CPU temperature.
Fan cooler set with 3 or 4 pins power connector are both available for CPUFAN
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is opened,
the chassis intrusion mechanism will be activated. The system will record this status
and show a warning message on the screen. To clear the warning, you must enter the
BIOS utility and clear the record.
1.CIN
TRU
2.Gro
und
CD-In Connector: JCD1
This connector is provided for external audio input.
4.R
3.Gro
und
2.Gro
und
1.L
•
•
•
