2-8
MS-7510 Mainboard
Important
- DDR2 memory modules are not interchangeable with DDR and the DDR2
standard is not backwards compatible. You should always install DDR2
memory modules in the DDR2 DIMM slots.
- In Dual-Channel mode, make sure that you install memory modules of
the
same type and density
in different channel DIMM slots.
- To enable successful system boot-up, always insert the memory modules
into the
DIMM1 first.
Installing DDR2 Modules
1. The memory module has only one notch on the center and will only fit in the right
orientation.
2. Insert the memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the DIMM slot.
3. The plastic clip at each side of the DIMM slot will automatically close.
Important
You can barely see the golden finger if the module is properly inserted in the
DIMM slot.
Volt
Notch
7510v1.0_2_Hardware.p65
2008/1/7,
下午
02:44
8
