(d) (e)
(f)
h) Please check and test the air pressure status inside the spa pool in the following way:
Please read the dial plate of manometer.
DO NOT OVER INFLATE. OVER INFLATION MAY CAUSE SPA POOL LEAKAGE AND VOID
THE MANUFACTURER WARRANTY.
i) Press the “bubble” button again to stop inflating. Remove the inflation hose from the air valve on the spa
pool. Screw the cover to the valve once the air pressure inside the pool is tested to be suitable.
j) Connect the inflation hose to the air valve of inflatable bladder(optional) and then press the “bubble”
button on the control panel to inflate it. When it’s going to be full without wrinkles on surface, please press
the “bubble” button again to shut off and stop inflating.
After filling in water, please check air pressure again and make sure the pin reads in
green sector.
When needs to inflate more air during use, please make sure it reads in green sector in
any term.
If it points to red sector, the spa is over inflated. Please unscrew the valve and release
some air.
Recheck the air pressure and make sure it reads within the green sector.
Please press the black button on the manometer, and air will be let out from the position
where the button locates. Keep pressing the button till the pin points to the green area.
If it points to yellow sector, the spa is well inflated. You may fill in water now.
TO AVOID OVER INFLATION CAUSED BY WARM WEATHER OR
SUNSHINE WHEN LEAVING MSPA FOR WEEKS INFLATED AND FILLED
WITH WATER IN TEMPERATURE HIGHER THAN 20°C, PLEASE REDUCE
THE AIR PRESSURE TO THE YELLOW SECTOR OF MANOMETER.
