k) Fill the Spa
Using a garden hose to fill the Spa until it reaches the area between two water lines printed inside the Spa
wall.
WARNING:
1. FILL IN WATER CAREFULLY ESPECIALLY FOR THE FIRST TIME OF USE. WATER
LEVEL MUST REACH THE MINIMUM WATER LINE BUT NOT EXCEED THE MAXIMUM
WATER LINE, OTHERWISE IT MAY CAUSE PUMP FAILURE.
2. PLEASE AVOID WATER SPILLAGE WHICH WILL CAUSE DAMAGE TO THE ELECTRIC
PARTS.
3. After filling in water, please check air pressure again and make sure the pin reads in green sector. When
needs to inflate more air during use, please make sure it reads in green sector in any term.
4. Please reduce the air pressure to the yellow sector of manometer, to avoid over inflation due to warm
weather or sunshine etc. after leaving Mspa for weeks inflated.
Warning: to avoid function failure and damage to the control system, please do not
operate until spa is filled with water to the low water mark.
(k) (l)
l) Place the zipper cover onto the spa and then put the inflatable bladder onto the spa pool, Fasten the zip
-
per and lock the cover to the spa by using the digital lock in the accessory pack.
Note:
Please remember to test and adjust the air pressure inside of spa pool before each
time of use.
Please cover zipper with wax once a week so as to make it smooth for operation and
avoid split.
How to change the combination of digital lock:
Original combination is set as 000
1) Push release button(a) in the direction of the arrow shown
and the lock will be released.
2) Set your desired combination by move the number wheel(b).
Please do not forget your new combination.
) Insert back the steel cable(c) to its end in the direction of the
arrow. The new combination is ready for use.
WARNING: Do not move the number wheels while the digital lock is open. Or you will
change the combination you just set. This will unable the digital lock. WARNING: The
cover is not a substitute for adult supervision; Children must be supervised at all
times around the Spa.
WARNING: Water attracts children; Always attach a spa cover and lock it after each
use.
(a)
(b)
(c)
(1)
()
()
