mspa B- 131 Luxury Exotic, Owner'S Manual And Warranty

10

Function Failure Alarm on the Control Panel

When power pack doesn’t work properly, there will be
corresponding error code displayed on the control panel in time:

Please check details from troubleshooting page.

Maintaining Spa Water

Poor water quality can be extremely hazardous to your health.
We recommend you do following things:

A: Please use filter cartridge.

Screw the filter onto the water inlet (lower fitting) on the spa wall by turning it clockwise.

Note:

Two filter cartridge, one is for use, one is spare.

Note:

 Do not use filter cartridge when only to heat water or to ensure good 

          heating performance. To avoid that the filter cartridge get damaged,
          do not use the filter when there are children or more than two persons
          in the pool. After finish using, replace the filter cartridge.

B: Clean your filter cartridge at least once a time after it worked continuously for 72~120 hours. 

The filter 

     cartridge should be replaced at least once a week depending on use.

Please make sure to unplug the power pack from the
electrical receptacle before the following actions.
1. Unscrew the filter cartridge by turning it counterclockwise.
2. The Filter Cartridge can be rinsed off with a garden hose
    and reused. However, if the Filter Cartridge remains soiled
    and discolored the Filter Cartridge should be replaced.

C: Change water every few days or use appropriate pool chemicals. All spas require the use of pool chemicals. 
Please consult your local pool supply retailer for more information about chemical maintenance. Pay close attention 
to the chemical manufacturer’s instructions. Spa damage resulting from misuse of chemicals and mismanagement of 
spa water is not covered by the warranty.

a. Water Balance: we recommend maintain your water pH between 7.2 and 7.8, total alkalinity between 80 and 
    120ppm and free chlorine between 3 to 5ppm. Use test strip to test your water chemistry before each use of the 
    spa, no less than once per week. Low pH will damage to the spa and pump. Damaged resulting from chemical 
    imbalance is not covered by the warranty.
b. Water Sanitation: Water Sanitation is the responsibility of the spa owner, achieved through the regular and periodic 
    (daily, if necessary) addition of an approved sanitizer. The sanitizer will chemically control the bacteria and viruses 
    present in the fill water or introduced during use of the spa.
c. Use wrench to screw off water inlet and outlet for regular check and clean to make sure they are not blocked.
    Also the use of wrench is only necessary in case of
    spa problems. After repair or replacement, assemble
    the spa pool and control box, and then screw clockwise
    firmly the water inlet and outlet onto the spa pool.

Note:
1. Leftover chemical from any sources should not be used in the spa tub.
2. Use chlorine powder not tablets to clean the water. Dissolve the power before pour into water.
3. Do not mix the water with any bath oil or bath salt.
4. Only use clean water to fill the spa tub. Salted water could damage the pump and filter.

HEATER FAILURE

FILTER FAILURE

BUBBLE FAILURE

(A)

(1)

(2)

water inlet and outlet