mspa B- 131 Luxury Exotic, Owner'S Manual And Warranty

11

                           Special Notice on Water Treatment

Please read about water quality and filter in user manual. Always shower before you enter your MSpa!

Please use test strip to test your water chemistry before each use of the spa, no less than once per week. The pH 
level must be between 7.2 and 7.8, total alkalinity between 80 and 120ppm and free chlorine between 3 to 5ppm. Too 
low of a pH level will result in excessive wrinkles and damage to the spa pool as well as corrosion in the motor unit. 
Too high of a pH level(hard water) will result in scale incrustation, e.g. sheets of white coagulations inside the filter 
pump, which will lead to block and non-working of the filter pump.

If you have any questions regarding chemicals, please contact local spa and pool water treatment specialist stores.

It is the responsibility of the owner to properly maintain the chemical balance and sanitation of the water. Mspa is not 
responsible for any damages that result from improperly mantained water. Improper water maintenance may result in 
voiding the warranty.

Spa Cleaning

Detergent residues or dissolved solids from bathing suits and chemicals will gradually accumulated in the water. If 
any dirt is visible in the water, change the water and clean the pool. Use a mild cleaner to wash the inner vinyl of the 
spa tub and rinse with clean luke warm water.

NOTE: 

Do not use hard brushes or abrasive cleaners.

Drainage

1. Turn off all the buttons on the control panel.
2. Unscrew the valve on outside of the spa pool
    till it is detached from the drainage structure,
    then connect the drainage hose adapter.
3. Find your garden hose and connect on to the
    drainage hose adapter in the other end.
4. Pull and open the cover of the drainage structure
    inside of the spa pool, water will flow out
5. Tilt the spa until no water flow out to empty the spa completely.

DO NOT leave your MSpa full of water if you will be away for a while and no one can take care of the pool. 
Drain the water before you leave and deflate the spa pool body a bit.

Spa Pool Repair

If the spa pool body is damaged, use the repair patch provided in the package. Clean and dry the damaged area in 
order to prevent dust and dirt from getting on the tacky glue. Apply glue to the PVC of the repair patch and quickly 
attach it onto the damaged surface. Smooth the surface to remove any air bubbles and allow it dry for roughly 3-10 
minutes. A secure and unnoticeable can usually be made.

Spa Storage

After the spa is drained, operate the Bubble function for another 20 minutes to dry the bottom ring. Remove the 
control panel from the spa tub, disassemble filter pump from the bottom of control box so as shown in the video. 
Drain the water and clean off any scale incrustation, like white coagulations inside the filter pump. Unscrew the 
complete part of the air valve on the spa pool and the spa will be deflated.

NOTE:

1. In the process of dismantling the filter pump, please check that there should not be any sharp objects on the 
    ground to damage the spa tub. The connector of the air pipe on the control box is exposed, please handle with 
    extra care. You can put some underlay under the spa tub to ease the weight, this also helps avoiding damage of 
    friction.
2. Consumers should keep the screws and other small parts during dismantling the filter pump.
   

  Any damage or missing parts caused by improper operation will void your warranty.