2016 Elite Bubble & Jet Spa Service manual
MSpa website: www.the-mspa.com
-
32
-
Answer: A level, stable surface is needed and all sharp objects must be removed. A ground cloth or tarp should
be placed under the spa prior to setting it up. If a site does in fact have hardy types of grass it is
recommended to remove these grasses before initial set up. Do not set up Mspa in a place where it can
be flooded with water.
1.3.
Question:
What other surfaces can be safely used to set up my spa?
Answer: The spa can be set up on grass or pavement that is completely smooth, level and stable. A ground cloth
or tarp is recommended. The spa should NOT be set up on sand or muddy ground that could possibly
shift around.
1.4.
Question:
What is the steepest slope that I am able to set up my spa on?
Answer: For best results the surface should be perfectly level. Pay close attention to the spa’s stability and
levelness in the early stages of filling your spa up with water. If after about an inch of water is
accumulated, and the water is not spreading out evenly, or the spa appears to be bulging to one side,
stop filling the spa, drain the water, and select a new site. If the spa is set up on a slope, the spa will be
lopsided and could collapse.
Never set up the spa on slope ground.
1.5.
Question:
What could cause the spa to be lopsided?
Answer: The base or bottom of the spa is not laid out flat (without wrinkles). The spa pool liner and cover must be
extended evenly around when the spa is filled with water.
1.6.
Question:
Can I set the spa up on a concrete patio?
Answer: Yes, but a ground cloth is highly recommended, and do not drag the spa pool across the concrete patio
as the abrasion may cause holes on the spa pool. The surface of the patio must be smooth, level, stable
and free of any sharp objects.
Part Two. Water Filling Capacity
2.1.
Question:
Approximately, how many gallons / liters of water does the spa pool hold?
Answer: When filled to 80% of max water capacity, as recommended, the spa pool water volume is
approximately:
For 4-6 person spa 1200ltr/320gal.
For 4 person spa 800ltr/211gal.
For 2-4 person spa 700ltr/185gal.
2.2.
Question:
How much water or how high of the spa pool shall the consumer fills water in the spa?
Answer: There are two water lines printed on the inner wall of the spa pool: Minimum Water Level and Maximum
Water Level, The customer needs fill the water into the spa between the two water lever liners.
Special Attention:
1.
Fill in water into the spa pool carefully especially for the first time of use. The water must reach the
minimum water line but not exceed the maximum water line, otherwise it may cause filter pump failure.
2.
Please avoid water spillage from the spa pool, the spilled water may flow into the control box and
damage the components inside the control box.
