2016 Elite Bubble & Jet Spa Service manual
MSpa website: www.the-mspa.com
-
33
-
3.
After filling in water, please check air pressure again and make sure the indication pin reads in
green sector. When needs to inflate more air during use, please make sure the indication pin also point
within green sector in any term.
4.
Please reduce the air pressure to the yellow sector of manometer to avoid over inflation due to warm
weather or sunshine etc. after leaving the spar pool outside under the sunshine for long.
2.3.
Question:
How long does it take to fill the spa with water?
Answer: Around 10 minutes or more, it depends on the hose size and water pressure. Remember to observe the
initial filling of the spa for several minutes in order to make sure that the spa is well setup and the bottom
is flat.
2.4.
Question:
What is the approximate depth of the water for spa?
Answer: If the spa is filled with 80% of its maximum water capacity, the depth is about 44-46cm.
Part Three: Heating Issue
3.1.
Question:
Is the heater defective if the heater button does not light up when the setting temperature is
lower than the environment or water temperature?
Answer: No.
3.2.
Question:
How to get a better heating result for the water inside the spa pool?
Answer: We strongly recommend the top lid of spa is covered with inflatable bladder when the heater function is
on to prevent the heat loss.
And also temp barrier mat can be used at the bottom to have better heat preservation result.
3.3.
Question:
How long does it take to heat up?
Answer: The heat increase rate is maxi. 1.2 to 2.5°C(1-3°F for US) per hour. If the water temperature starts about
24°C (75°F), and you want to warm water to 38°C (100°F), it'll take about 7-10hours
3.4.
Question:
How high the water temperature will be increased after using heater?
Answer: Maximum 42
℃
for EU spa or 104
℉
for US spa while there may be some indication tolerance which will
indicate about 38
℃
or 100
℉
. This is normal. And also please note that the following conditions will lead
to slow and even heating without heating phenomenon:
1.
Environmental temperature lower than 10°C(50°F)
2.
Outdoor wind force above Gentle breeze/F 3
3.
Environmental temperature lower than 10°C(50°F) and wind power above Gentle breeze/F 3
4.
Activate bubbling system when heating
5.
Spa lid is not covered or improperly covered when heating
So the customer is recommended to fill spa with warm water for quick heating and energy saving
if necessary.
3.5.
Question:
Why is the temperature showing on the control panel differs from the actual water temperature?
Answer: Before entering the spa tub, users should measure the water temperature with an accurate thermometer
since the tolerance of water temperature regulating devices may vary as much as +/- 2
℃
( 5
℉
).
3.6.
Question:
If turned off at night time, how much will the temperature drop?
