2019 Premium Concept Elite Service Manual
Visit our website at: www.the-mspa.com
- 19 -
7. Put the new bubble generator; assemble the heat
shrinkable sleeving; connect the leading wire from
the bubble generator and power cable.
8. Connect the transparent protective suit on the lead to
the joint
，
assemble the heat shrinkable sleeving;
Tie-binding after fusing shrinkage
9
、
Assemble the control box in reverse order. (Video available)
4.4 How to replace heating element(B9 B9301284)
1
、
Take out the control box
2
、
Loosen four screws (ST4*60) from the bottom of the
cabinet
3
、
Loosen five screws (ST4*15) from the rear cover
of the cabinet; Loosen two screws (ST4*15) from the
bottom of the cabinet
4
、
Take out the internal cabinet and power board
；
5
、
Loosen three screws from the fixed junction box;
disassemble 4 sets black pin-cables
；
6
、
Remove 4 screws and open the wire connection box;
cut off the bindings and take out the 2 heating wires,
