2019 Premium Concept Elite Service Manual
Visit our website at: www.the-mspa.com
- 40 -
Auto-off 10 minutes
Waiting for 10 minutes and turn on the bubble button
again.
Inflation knob is in "ON" position
Turn the knob to "OFF" position and turn on the bubble
button again.
Control panel failure
Contact the Mspa service center or partner for warranty
repairing work.
Filter pump does
not work
Power failure
Check power supply
Filter cartridge stuck by dirt or other
objects
Clean or replace the filter cartridge
Low water level
Add more water to reach the minimum water line.
Spa tub in an
abnormal shape
Extra air pressure by strong sunshine
Please check the air pressure and release air if
necessary:
During hot weather, it's recommended to check if it is
necessary to release some air to avoid any possible
damage to the spa pool.
Spa loses air
Air valve got loosen
Inflate the spa till yellow section of the manometer is
pushed out. Make sure the valve is screwed tightly.
Replace the valve if necessary.
Hole or spilt on the spa tub
Put soap water in a squirt bottle and spray on seams. If
there is a leak, small bubbles will come out. After you
find the leak, clean and dry the leaking area, then use
the repair patch comes with your spa to repair.
Water not clean
Insufficient filtering time
Extend filtration time
Dirty filter cartridge
Clean or replace filter cartridge in time
Improper water maintenance
Refer to the chemical information recommended
EO
Water temperature is lower than zero
degree or too high
Refer to the checking flow for self-checking first.
Change the water or replace a new temperature sensor
Temperature sensor failure
E1
Flow switch blocked
Refer to the checking flow for self-checking first.
Contact the local Mspa service center or partner for
warranty repairing help.
Filter failure
Water level is not at minimum water
line
Add more water to reach the minimum water line.
