2019 Premium Concept Elite Service Manual
Visit our website at: www.the-mspa.com
- 6 -
Heat Preservation Mat
is helpful to reduce heat loss from the bottom and it provides better heat insulation results
together with the inflatable bladder in use. It is recommended to have the MSpa heat preservation mats in between the
SPA and ground. Consumers can also apply similar mat which is made of foam material or other material with heat
insulation function.
It’s only possible to set up and leave the spa at an outside temperature lower than 4°C as long as the spa has a
constant water temperature guaranteed at above 4°C. The spa can be used under low-temperature
environment and temperature down to maximum -10°C ONLY if it is set up properly to ensure no frozen water
inside control box, pipes or spa pool.
2.2 Filter Cartridge
MSpa filter cartridge
– Item No. B0301964/B0302860 is suitable for all Mspa bubble spa products.
2.3 Inflate and Deflate the Spa (For Premium/Elite series only
)
Note:
Check before inflation whether the manometer cap is screwed up tight on the valve of the pool
body. If not, please tighten and then inflate. After inflation, the manometer cannot be removed,
otherwise, air will be released.
When the Yellow section is pushed out, the Spa inflation is completed. You can fill the Spa with water.
After water filling is completed. Check air pressure once again to ensure the manometer reaches
Green section. Always ensure the manometer is on Green section at use.
If the White section of the manometer appears, the spa is over inflated. Rotate the valve cap counter
clockwise, have the air released till the Green section is pushed out, then tighten it clockwise.
To avoid over inflation caused by warm weather or sunshine when leaving spa for weeks inflated and
filled with water in temperature higher than 20°C (68°F), please release some air to make sure the
manometer is always on Yellow section.
Spa Deflation
1. Unscrew the manometer cap on the spa pool to deflate the spa.
2. Once the deflation is completed, screw the cap back.
Stop pressing bubble button and turn the knob back to <OFF>
