6.4
6
16
● Water level must not exceed the Maximum line to avoid pump failure.
● Never pour water with a temperature higher than 104°F (40°C) into the spa directly.
6.3 After water filling, double check the spa pool air pressure to make sure the manometer points out the
Green section.
6.4 Place the inflated air bladder and the zipper spa cover over the spa tub. Make sure the spa cover is
zipped and locked by the digital lock in the accessory pack.
IMPORTANT:
● Inspect the spa pressure regularly for leak, premature wear, or deterioration.
● Check and wax the zipper regularly, to make it smooth for operation and to avoid splits.
6.
6.5 Turn on the Heater on the spa wired controller, refer to the “Wired Controller Operation” section.
Maximum heating temperature is 104°F (40°C). Hourly heating rate is about 2.5°F-3.5°F
(1.5°C-2°C).
Zipper Operation
7.1 Digital Lock Operation
The default password is
“000”
. Follow the steps below to change the password:
● Push the button (a) in the direction of Fig.7.1.(1) to unlock the digital lock.
● Set your preferred password in 3 digits by turning the number wheel (b), see Fig.7.1.(2).
● Insert back the cable (c). The new password is set.
7.
Water Filling
6.1 Check the spa mark is at the selected area and point
the drain valve toward a suitable draining area
before inflation.
6.2 Fill the spa tub with fresh water below
Maximum
line
marked on the inside of the spa wall. Do not over fill
the spa. It is recommended to fill the spa with
lukewarm water for quick heating and energy saving.
WARNING:
