12
Spa Tub Assembly
1. Take out the foam mat and spread it over the cleared area.
2. Place the ‘open-end panel’ towards the corner where you intend to install your external control box.
3. Connect two panel pieces together by sliding a corner beam between them and then do the same with the remaining panels.
4. Place the sponge rails on top of the wooden panels with the shorter side of the rail on the inside of the spa tub.
5. Spread out the spa liner inside the spa wall frame and make sure the pipes go through the holes on the panel.
6. Stretch the top trim of the spa liner over the sponge rails. Lock the silver buckle on the trim onto the metal twist lock on the corner beams.
7.
Heater Resetting
:
Please reset the heater when the product is used for the first time or after a long period of storage.
Operation:
Find the yellow ring as shown in the picture. Pull it down gently and then release it.
Note:
The heater cannot work or be reset when the water temperature or ambient temperature is higher than 38°C (100°F).
8. Ensure all the rubber sealing rings are in place.
9. Connect the control box to the spa by lining up the numbers (1 to 1, 2 to 2 and 3 to 3). Securely hand-tighten the connectors.
NOTE:
Do not use tools to tighten.
10. Attach the U-shape cover to the spa control box.
NOTE:
The U-shape cover must be installed before using the spa.
CAUTION:
Do not sit on, lean on,
cover or place any objects over the spa control unit.
SPA SETUP: TUSCANY
ASSEMBLY - TUSCANY
This side face out
3.
4.
6.
7.
8.
9.
10.
5.
1-2.
1
1
2
2
3
3
Inside
control box
