13
Inflating the Spa Air Bladder
1. Open the inflation valve and insert the inflation hose into the valve.
NOTE:
Ensure that you use the correct nozzle.
2. Use the foot pump to inflate until it is firm to the touch but not hard.
3. Disconnect the inflation hose from the valve, then close and push in the inflation valve.
NOTE:
If you need to add some air to the air bladder after it has been set up, please refer back to this “Inflating the spa air bladder" section.
Installing the Filter Cartridge
1. Attach the filter cartridge base to the spa tub inlet grid (upper position) and turn it slightly to secure.
NOTE:
The filter cartridge base is designed to be
screwed on and off. Never exert force as this could cause damage.
2. Put the mesh cover on the filter cartridge then attach the filter cartridge to the base.
NOTE:
Inflate the spa tub first before installing the filter cartridge.
NOTE:
Always use a filter cartridge when the spa is in use and filled with water.
Filling the Spa with Water
1. Before filling with water ensure the bottom drain valve cap is securely closed.
2. Fill the spa tub with fresh water to a level between MIN and MAX marked on the inside
of the spa wall.
WARNING:
Do not overfill the spa.
Do not operate the spa until the water reaches the MIN mark.
Never move the spa tub when there is water inside it and/or when the control box is
attached, as this may damage the spa or control box.
Never pour water with a temperature higher than 38°C (100°F) into the spa directly. We
recommend that you fill the spa tub with lukewarm water to heat it more quickly and save
energy.
Heating the Water
1. Place the air bladder and spa cover over the spa tub, and make sure the spa cover buckles are locked using the key provided after pulling the buckled
straps tight.
2. Ensure the spa is plugged into an electrical socket and see the “ALL-IN-ONE CONTROL PANEL” section for further details on operation.
NOTE:
Always keep the spa cover on to minimize heat loss when heating the water.
3.
1-2.
