mspa F-MO061, Owner'S Manual

BUBBLE MASSAGE 

Press the           

BUBBLE

 button to turn the function on; hold down the BUBBLE button for 3 seconds to turn the function off. 

The bubble setting can be adjusted to three different levels. The default setting is at level 2              (500W). Press the 

BUBBLE 

button to switch 

the setting to level 3              (720W). Press it again to switch to level 1              (300W). 

IMPORTANT:

 Do not turn on the massage system when the cover is attached. Air can accumulate inside the spa and cause irreparable damage 

and bodily harm.

NOTE:

 The bubbling massage function will shut down automatically after every 20 minutes of operation as a safety precaution. This can be 

reactivated after 10 minutes by pressing the BUBBLE button again.

HEATING TIMER

To set the number of hours 

FROM NOW

 when the heater will activate:

1.  Press the           

TIMER

 button to enter pre-setting mode. The TIMER icon shown on the LED display. 

2.  Pressing the         

UP 

or         

DOWN

 button will cause the LED to flash. While it is flashing, you can adjust the number of hours before heater 

     activation (from 1 to 99 hours). The desired timer setting will remain on the LED display for 3 seconds to confirm the value.

To modify the timer setting: 

Press the 

Timer

 button again and use the 

UP

 or the 

DOWN

 button to adjust.

Cancel the setting:

 Press the 

TIMER

 button for 3 seconds.

NOTE: 

Activating the heating system or rebooting the spa will cancel the timer setting.

UVC SANITIZER

Press the           

UVC

 button to turn the UVC sanitizing system on/off. The UVC icon shown on the LED display means the UVC sanitizing system 

is activated.

OZONE

Press the           

OZONE

 button to turn the function on / off. The Ozone icon shown on the LED display means the function is activated. The 

Ozonator will shut down automatically after operating for 2 hours. 

NOTE:

 For bathers’ safety concern, please do not soak in the spa when the Ozone is on. The Ozone function cannot be turned on when JET or 

BUBBLE function is on.

SAFETY LOCK

Press the         

UP

 and         

DOWN

 buttons at the same time for 3 seconds to lock/unlock the controller. In safety lock mode, the controller is 

disabled and the spa retains all previous settings. 

Celsius/Fahrenheit Toggle Button

The temperature can be displayed in either Celsius or  Fahrenheit. Press the           

DOWN

 button for 3 seconds to toggle between the two 

options.

BUBBLE

TIMER

15

UP

DOWN

UP

DOWN

DOWN

1-99H

TIMER

BUBBLE

3s

UP

DOWN

3s

DOWN

+