f) Screw the cover to the valve once the air pressure inside the pool is tested and
appropriate.
g) Inflate the top bladder by turning on the electric pump. Stop inflating when it is
going to be full with no wrinkles on surface
h) Connect the control box to the spa, and screw the hoses tight.
i) Fill the water into the spa. Use a garden hose to fill in the water until it reaches
the area between the Maximum and Minimum water lines printed inside the spa
wall.
WARNING:
1. Fill in water carefully especially for the first time of use. Water level must
reach the minimum water line but not exceed the maximum water line,
otherwise it may cause pump failure.
2. Please avoid water spillage which will cause damage to the electric parts.
3. After filling in water, please check air pressure again and make sure the pin reads in the Green Sector. When
needs to inflate more air during use, please make sure the pin must always reads in the Green Sector at all times.
4. Please reduce the air pressure to the yellow sector of manometer, to avoid over inflation due to warm weather or
sunshine etc. after leaving the spa inflated or with water for weeks.
Warning:
to avoid function failure or damage to the control system, do NOT operate any functions until the spa is
filled with water with appropriate water level.
j) Put the inflatable bladder onto the spa pool first, and then close the spa with zipper cover. Close the spa
completely, lock the cover to the spa pool body by using the digital lock in the standard accessory pack.
Note:
Remember to test and adjust the air pressure inside the spa pool before each time of use.
Apply wax to the zipper regularly to make it smooth for operation and to avoid splits.
How to change the combination of digital lock:
Original combination is set as 000
1) Push the release button(a) in the direction of the arrow shown and
the lock will be released.
2) Set your desired combination by move the number wheel(b).
Please do not forget to press your new combination.
3) Insert back the steel cable(c) to its end in the direction of the arrow.
The new combination is ready for use.
WARNING: Do not move the number wheels while the digital lock
is open. Or you will change the combination you just set. This
will unable the digital lock.
WARNING:
The cover is not a substitute for adult supervision; Children must be supervised at all times around the
spa tub.
WARNING:
Water attracts children; Always attach the spa cover and lock it after each use.
(a)
(b)
(c)
(1)
)
3
(
)
2
(
11
If the red section of the manometer appears, the spa is over inflated. Press the
black button on the manometer, have the air release until you see it points the green
section. Recheck the air pressure and make sure it only appears the green section
in any term.
DO NOT OVER INFLATE. OVER INFLATION MAY CAUSE SPA POOL LEAKAGE
AND VOID THE MAN UFACTURER WARRANTY.