13
7.7 Turn on the Heater on the controller, refer to the “Controller operation” section. Maximum heating
temperature is 42°C(108°F). Hourly heating rate is about 2°C-2.5°C(3.5°F-4.5°F) for 2 and 2+2 persons,
1.5°C-2°C(2.5°F-3.5°F) for 4 persons and 1.2°C-1.8°C(2°F-3°F) for 6 persons.
7
7.6
7.5
Lock
Unlock
7. Water Filling
7.1 Check the spa liner is at the selected area and point the
drain valve toward a suitable draining area before
inflation. Make sure the drain valve is securely
tightened.
7.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the inside of the
spa wall.
Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick heating and energy
saving.
WARNING:
Ɣ:DWHUOHYHOPXVWUHDFKWKH0LQLPXPZDWHUOLQHEXWQRWH[FHHGWKH0D[LPXPOLQHWRDYRLGSXPS
failure.
Ɣ1HYHUSRXUZDWHUZLWKDWHPSHUDWXUHKLJKHUWKDQ
40°C(104°F) into the spa directly.
Ɣ7RDYRLGFRQWUROV\VWHPIDLOXUHGRQRWRSHUDWHWKHVSDXQWLO
water reaches the Minimum line.
7.3 Check the connecting tub and make sure there is no water
seeping. Assemble the “U” shape cover.
7.4 Insert the inflatable bladder into the buckled cover. (Keep valve
and printing towards outside)
7.5 Inflate the bladder with the hand pump.
7.6 Place the cover over the spa tub and insert the buckle to the
base that attached on the spa tub.
7.3
Lock the Buckle
Ɣ,QVHUWWKHEXFNOHRQWKH*URXQG0DWLQWRWKH6SD
cover buckle, until you hear a “Click” sound.
Unlock the Buckle
Ɣ3LQFKERWKVLGHVRIWKHORFNHGEXFNOHDQGSUHVV
down the round dot in center in the same time. Press
down the center button and release the lock.
