mspa PM-610S Tuscany, Owner'S Manual And Warranty

20

DRAINAGE, CLEANING AND STORAGE

Spa Drainage

1.   Turn off all the buttons (heater, filter and bubble) on the control panel unit. 

2.   Connect the drain valve adapter to a garden hose and point the other end of the garden hose to a 

suitable draining area with local environmental regulations (Fig.1) 

3.   Remove the drain valve cap from the outside of the spa tub and attach the drain valve adapter with the 

garden hose to the drain valve (Fig.2) 

4.   From the inside of the spa tub, open the drain valve cap, water will start to flow out through the garden 

      hose (Fig.3)

5.   When the water stops draining, release the buckle and lift the spa liner from the opposite to the drain,

      leading any remaining water to the drain and empty the spa water completely. (Fig.4)
6.   Press                Bubble button to dry out any water in the piping system. Operate the bubbling function

      for 15 minutes to blow out all the remaining water. (Fig.5)

7.   When the water stops draining, use a clean towel to wipe up any remaining water and moisture on the

      spa tub and spa control panel. (Fig.6)

garden hose

1

4

5

6

2

3

17

15

Spa Tub Cleaning

If dirt is visible in the water or water becomes cloudy and proper water chemistry does not clear it up, change the 

water and clean the spa tub. 
While spa water is empty, remove the cartridge from the inside of the spa tub wall, clean and /or replace the filter 

cartridge. Use a sponge and mild soap solution to wipe away any soil or stains on the inside of the spa wall. Rinse 

thoroughly before refilling with clean water. 

IMPROTANT:

 Do not use steel wool, hard brushes or abrasive cleaners.

Spa Tub and Air Bladder Repair

Use the enclosed repair patch to repair any puncture: 

1.    Clean and dry the area to be repaired thoroughly 

2.    Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)

®