●
The plot can be stopped with the "Pause" key at any time, for example allowing you to
adjust knife settings while still in the cut job.
●
You can use the "OK" key to continue to run the cut job.
Settings and operation
Moving the cutting head
Pressing the arrow keys lets you move the cutting head left or right, as well as move the material
forwards or backwards. The corresponding X and Y coordinates are shown on the display.
Setting the zero point
To set the correct starting point for cutting, move the cutting head and material using the arrow
keys, so that the knife is located in the front right corner of the material. Now confirm this zero
point by pressing "OK".
Page 11
ESC60
Summary of Contents for ESC60
Page 3: ...Page 3 2 ESC60...