MSSC ESC60, Operating Instructions Manual

 
These settings are queried in sequence: 

●

Baud rate  configurable to 38400, 57600, or 115200, depending on the value configured 
for the interface on the computer  only when connecting via serial port.   

●

XP and YP  in the second and third menu point, you can calibrate the stencil cutter 

correctly. Correction may be required here due to wear to the mechanical parts. The X   
and Y scaling of the data can be changed by changing the XP and YP values. If, for   
example, an object for which a length of 100 cm was entered on the computer is cut on 

the stencil cutter to a length of only 98cm, it is necessary to correct the corresponding 

scaling value on the plotter. Otherwise, these values should not be changed.

●

Reset  settings  here you can restore the stencil cutter's factory settings. To do so, the  
right arrow key must be held for 3 seconds.

●

Firmware  here you can view the firmware version installed on the cutter.  

.

Calibration: 

Before the first use, the cutter requires an initial calibration to determine the correct blade offset.

DrawCut provides two procedures to achieve this, one fast and one detailed option.

●

The first step is to open the "Vinyl Spooler". 

Page 13

ESC60