4. Fan blade
5. Safety grill fastening
6. Rear safety grill
7. Motor shaft
8. Motor housing
9. Oscillation switch
10. Tilt adjustment
11. Body
12. Fan speed switch
13. Base
3.3.
Device use
1. Connect the device to a power socket.
2.To set the desired tilt angle, loosen the tilt adjustment screw and - using the tilt
lock knob - set the fan to the desired position, then tighten the tilt lock knob.
3. Set the desired speed:
a) for the MSW-FFT-01 and MSW-FFT-03 devices:
• 0 - fan turned off
• I - low speed
• II - average speed
• III - high speed
b) for the MSW-FFT-04 device:
• 0 - fan turned off
• I - low speed
• II - high speed
4. To turn on the oscillation function, press the oscillation switch. To turn off the
oscillation function, pull the oscillation switch up.
5. After using the fan, set the speed to "0" and disconnect the device from the
power socket.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each
cleaning, adjustment or replacement of accessories.
•
Wait for the rotating elements to stop.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
d)
Do not spray the device with a water jet or submerge it in water.
e)
The device must be regularly inspected to check its technical efficiency and
spot any damage.
f)
Use a soft, damp cloth for cleaning.
