UK
INSTALLATION
7.
Reconnect the wire harness and the antenna and be careful not to pinch any wires
or cables.
8.
Slide the unit into the sleeve until it locks into place.
9.
To further secure the unit, use the supplied metal strap to secure the back of the
unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to
attach one end of the strap to the mounting bolt on the back of the unit. If necessary,
bend the metal strap to fit your vehicle’s mounting area. Then use the supplied
hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of
metal strap to a solid metal part of the vehicle under the dashboard. This strap
also helps ensure proper electrical grounding of the unit.
Note: to install the short threading terminal of the mounting bolt to the back of
the unit and the other long threading terminal to the dashboard.
10.
Reconnect the cable to the vehicle battery’s negative (-) terminal.
Then replace the outer trim ring and install the unit’s front panel. (see the steps of
“using the detachable front panel”).
Removing the unit
1.
Make sure the ignition is turned off, then disconnect the cable from the vehicle
battery’s negative (-) terminal.
2.
Remove the metal strap attached the back of the unit (if attached).
3.
Press the release button to remove the front panel.
4.
Lift the top of the outer trim ring then pull it out to remove it.
5.
Insert both of the supplied keys into the slots at the middle left and right sides of
the unit, then pull the unit out of the dashboard.
Mounting Bolt
Spring Washer
Tapping Screw
Plain Washer
Hex Nut
Metal Strap
30
UK