Assembly & Set-Up
3
7
Contents of Carton
One Chipper Shredder
•
One Operator’s Manual
•
One Engine Operator’s Manual
•
One Hopper Assembly
•
One Bag
•
One Chipper Chute
•
One Chute Deflector
•
One Safety Glasses
•
One Bottle of Oil
•
Assembly
NOTE:
This unit is shipped without gasoline or oil in the engine.
Fill up gasoline and oil as instructed in the accompanying engine
manual BEFORE operating your chipper shredder.
Hopper Assembly
Remove six hex nuts and washers from the weld studs on
1.
the impeller housing. Do not remove the support plate. See
Fig. 3-1A.
Place hopper assembly into position in front of impeller
2.
housing, aligning holes in hopper assembly collar with
weld studs. See Fig. 3-1B.
Slide hopper assembly onto weld studs and replace
3.
washers and hex nuts. See Fig. 3-1C. Do not tighten
completely.
Lift hopper assembly up to impeller bracket assembly. See
4.
Fig. 3-2A.
Slide the release rod out slightly to hook the hopper
5.
bracket onto the rod. See Fig. 3-2B.
Tighten the six hex nuts that secure hopper assembly to
6.
impeller housing and also tighten the hex nuts that secure
hopper bracket to hopper assembly.
A
B
C
Figure 3-1
Chute Deflector
Remove the wing knobs from each side of the lower
1.
impeller housing. See Fig. 3-3A.
A
B
Figure 3-2
A
A
B
B
Figure 3-3
Summary of Contents for 24A-45M3000
Page 19: ...Notes 10 19...
