Sine Wave 2-8 kHz Series A Filter
2
Part No. INSTR-020 REL. 080310
2. INTRODUCTION
This manual was specifically developed to
assist in the installation, interconnection and
operation of the MTE Corporation Sine Wave
filter.
This manual is intended for use by personnel
experienced in the operation and
maintenance of electronic drives. Because of
the high voltages required by the filter and
drive and the potential dangers presented by
rotating machinery, it is essential that all
personnel involved in the operation and
maintenance of this filter know and practice
the necessary safety precautions for this type
of equipment. Personnel should read and
understand the instructions contained in this
manual before installing, operating or
servicing the filter and inverter to which it is
connected.
Upon Receipt of this Filter:
The MTE Sine Wave Filter has been
subjected to demanding factory tests before
shipment. Carefully inspect the shipping
container for damage that may have occurred
in transit. Then unpack the filter and carefully
inspect for any signs of damage. Save the
shipping container for future transport of the
filter.
In the event of damage, please contact
and file a claim with the freight carrier
involved immediately.
If the equipment is not going to be put into
service upon receipt, cover and store the filter
in a clean, dry location. After storage, ensure
that the equipment is dry and that no
condensation has accumulated on the
internal components of the filter before
applying power.
Repair/Exchange Procedure
MTE Corporation requires a Returned
Material Authorization Number before it can
accept any filters that qualify for return or
repair. If problems or questions arise during
installation, setup, or operation of the filter,
please call us for assistance at
:
Director of MTE corporate quality:
Phone: 262-253-8200 ex. 148
FAX: 262-253-8210
Summary of Contents for Sine Wave Filter
Page 3: ......