MTI 840 Series, User Manual

 15

Safety Lockout

The Safety Lockout disables all commands to prevent unwanted or inadvertent movements.

To enable the Safety Lockout, press the following sequence of buttons (within 1 second between presses): 

Stop, Stop, Back Up, Stop.

To disable the Safety Lockout, press the following sequence of buttons: 

Stop, Stop, Back Down, Stop.

Controls

ITEM DESCRIPTION

FUNCTION

FOOT AND HAND CONTROLS

1

Lift Up/Down Buttons

Raises or lowers the stretcher bed top by pressing the desired direction.

2

Back Up/Down Buttons Raises or lowers the backrest by pressing the desired direction.

3

Tilt Up/Down Buttons

Decreases or increases the angle of the seat by pressing the desired direction.

4

Foot Up/Down Buttons

Raises or lowers the footrest by pressing the desired direction. The footrest will automatically extend 

while pressing Foot Up and, when held, will continue to extend the foot fully. The Foot Down Button 

will automatically retract the foot as it approaches the floor. 

5

Stop Button(Emergency 

Stop Button)

Stops all movement of stretcher bed.

6

Swivel Button

This button is non-functional on this stretcher bed.

7

Home Button

The Home Button moves the stretcher bed to either a Programmed Home Position or an ADA Compliant 

Home Position. The Programmed Home Position is user programmable and can be saved in any 

preferred position.

Momentary Button Setting:

 Press and release the Home Button to move the stretcher bed to the 

Programmed Home Position. Press and release the Home Button twice within 1 second to move the 

stretcher bed to the ADA Compliant Home Position (Lift Down, Tilt Down, Back Up, and Foot Down 

and Retracted). To save a new Programmed Home Position, position the stretcher bed to the desired 

position then press and hold the Home Button for 10 seconds. The stretcher bed will play a high-low-

high tune after the Programmed Home Position has been saved.

Maintain Button Setting: 

Press and hold the Home Button to move the stretcher bed to the 

Programmed Home Position. After arriving at Programmed Home, release the Home Button and 

then press it again within 1 second to move the stretcher bed to the ADA Compliant Home position 

(Lift Down, Tilt Down, Back Up, and Foot Down and Retracted). To save a new Programmed Home 

Position; position the stretcher bed to the desired position, press and release the Stop Button twice, 

then hold the Home Button for 10 seconds. The stretcher bed will play a high-low-high tune after the 

Programmed Home Position has been saved.

8

Program Buttons
(P1, P2, P3, P4)

The Program Buttons move the stretcher bed to a user defined Program Position. NOTE: The stretcher 

bed has no pre-existing Program Positions upon arrival and will only beep and not move until Program 

Positions have been saved.
The Program Buttons have two button settings that can be changed by the user.

Momentary Button Setting:

 Press and release

 to automatically move the stretcher bed to the 

Program Position. To save a Program Position, position the stretcher bed to the desired position then 

press and hold a Program Button for 5 seconds. The stretcher bed will play a high-low-high tune after 

the position has been saved.

Maintain Button Setting:

 Press and hold

 the button to move the stretcher bed to the Program 

Position. To save a Program Position; position the stretcher bed in the desired position, press and 

release the Stop Button twice, then hold the Program Button for 5 seconds. The stretcher bed will 

play a high-low-high tune after the position has been saved.