I N S T A L L A T I O N I N S T R U C T I O N S
Read all instructions before installing tub. Installer / product owner is responsible for complying with all
state and local codes. Warranty coverage will be void if unit is not tested and installed per the enclosed
instructions.
MTI Baths strongly recommends to use a liscensed professional to install this product.
WARNING: Certain cleaning products will permanently damage the tub surface. Read product
label carefully before applying any cleaning product. Never use anything abrasive, aerosol
sprays or any product that is described as “scrubbing bubbles”.
BEFORE INSTALLING, INSPECT TUB THOROUGHLY:
A. Damage from shipping or delivery must be reported to carrier immediately.
Do not instal
l
damaged tub. MTI Baths is not responsible for damage occurring in transit
.
B. Factory defect must be reported to factory before tub is installed. Defects or damage
claimed after installation will be excluded from warranty.
C.
Important
- Measure tub on site carefully before framing or cutting any deck materials.
Specifications are subject to change without notice. MTI is NOT responsible
for any preparatory
labor or materials.
CAUTION: DO NOT LIFT TUB BY PIPING OR PUMP. DO NOT RUN PUMP DRY.
To Do So May Cause Damage Not Covered By the Warranty
A T T E N T I O N I N S T A L L E R !
THIS TUB MUST BE TESTED FOR OPERATION AND LEAKS PRIOR TO ENCLOSURE OF SURROUNDING
AREAS. FAILURE TO DO SO WILL VOID WARRANTY. THIS TUB WAS WATER TESTED AT THE FACTORY
AND FOUND TO BE FULLY OPERATIONAL AND LEAK FREE PRIOR TO SHIPPING. FREIGHT HANDLING AND
JOB SITE EXPOSURE MAY HAVE DETERIORATED THE TUB’S CONDITION. IT IS THE RESPONSIBILITY OF
THE INSTALLER TO THOROUGHLY TEST THE UNIT PRIOR TO INSTALLATION. TUBS ARE INTENDED, AND
WARRANTIED, FOR INDOOR USE ONLY.
TEST PROCEDURES
1. Place the tub on a flat surface such as the driveway.
2. Seal the drain with tape.
3. Fill tub to overflow and allow tub to stand for five minutes
without the pump runing
. Examine all
fittings carefully for leaks.
NOTE:
The overflow is a plumbing device designed to prevent water from
reaching a certain level in your tub. DO NOT, under any circumstances, tape off or block the overflow
in any way. Any controls located above the normal water line are designed to be water-resistant, not
water-proof. The controls will not leak under normal usage, however, they are not warranted against
leaks when improperly used or subjected to conditions for which they were not designed.
4. Plug the pump, blower and/or in-line heater into a 110v GFCI outlet. Start the pump, blower and/or
in-line heater, and check all fittings for leaks.
5. Check that all optional equipment is functioning properly and that the features on the tub match
exactly what was ordered.
6.
If any leaks or operating problems are discovered, do not complete installation until
problems are resolved. MTI Baths will not be responsible for any costs involved with
removing or reinstalling the tub, or for the costs of any surrounding materials.
See troubleshooting section of this manual.
Always protect tub from construction damage by using a protective cover. Damage, including chips
and scratches, incurred at the jobsite is excluded from warranty.
Do not store tub in temperatures below
32 degrees Fahrenheit. Proper waste and overflow installation is the responsibility of the installer. MTI does
not warrant leaks associated with improper waste and overflow installation.
2
