FREEDOM MICRO
®
II POWER
MANUAL
3
MTI P/N 063-00425 rev A ©2022 MTI All Rights Reserved
www.MTIGS.com | T:800.426.6844
1
3
2
4
Route the cable as desired and attach the baseplate with
the included screws.
Routing out
the back
Routing out the bottom
Peel the red film from the adhesive.
Place Micro position in desired location. Press down on
the base plate for 10 seconds for full adhesive contact.
Allow 24 hours for full adhesion.
Use the individual power supply and plug it into the
nearest outlet. The socket-outlet shall be installed near
the equipment and shall be easily accessible.
Utilisez l’alimentation individuelle et branchez-la dans la prise la
plus proche. La prise de courant doit être installée à proximité de
l’équipement et doit être facilement accessible.
BASEPLATE OPTIONS - ADHESIVE
1
2
3
Do not cut power cable.
ADHESIVE POSITION REMOVAL
