RAPIDDOC
™ TABLET KIOSK
INSTALLATION GUIDE
5
MTI P/N 063-00180 rev B ©2018 MTI All Rights Reserved
www.armoractive.com.com | T:800.426.6844
1
2
1
2
CABLE ROUTING
1.
1.
2.
2.
1. Through Hole Cable Routing
2. Table Top Cable Routing
3. Six USB Ports (Pro version only)
4. Ethernet (Pro version only)
5. Power
3.
5.
4.
REMOVING THE ENCLOSURE (OR TABLET) MANUALLY
REMOVING THE ENCLOSURE (OR TABLET) VIA RFID
Insert the Red Handle Tool into the security screw hole
at the side of the RapidDoc base-disk under the tablet.
Turn the Red Handle Tool clockwise until resistance is
felt (about halfway) and hold.
NOTE: Do not grab the
tablet until after you twist the Red Handle Tool.
While holding the Red Handle Tool, remove the tablet
using one hand on the bottom left or right hand corner.
Place the RFID Access Card until the base clicks.
NOTE:
Do not grab the tablet until after you hear the click.
Remove the tablet using one hand on the bottom left or
right hand corner.
