G. Finish Strip
Parallel to deck flutes
(required for metal deck
B. Bottom Section
A. Top Section
H. Closure Strip
Perpendicular to deck flutes
(required for metal deck)
C. End Cap Insert
Slides into exposed end of bottom section
Installation Guide for
EdgeBox RI
FM
Approved
ANSI/SPRI/FM4435/ES-1 TESTED
FINISH STRIP
(TYPE 2 SHOWN)
CORRUGATED ROOF
DECK BY OTHERS
CONCEALED
JOINT SPLICE
FASTENER
FASTENER
6" F.E. / 12" O.C. (TYP. 4)
TOP SECTION
BOTTOM SECTION
OPTIONAL INSULATION
BY OTHERS
MEMBRANE BY OTHERS
ROOF SIDE
A
B
H
OPTIONAL
INSULATION
(BY OTHERS)
ROOF DECK
(BY OTHERS)
G
C
E
12" OC
D
F
D. Fastener
Included and required
F. EdgeBox Spine
Required for height or width greater than 6"
CLOSURE STRIP
FASTENER
PROVIDED
E. Fastener
Size varies based on height of EdgeBox
min. 1" penetration required
NOTES:
#1 - Isolate all metal parts from ACQ treated wood or other galvanically
incompatible material with appropriate membrane material.
#2 - Appliance attachments, such as lightning rods, signs, or antennae
that penetrate the edge system, induce a galvanic reaction, or otherwise
compromise the effectiveness of the roof edge system, shall be eliminated
or isolated to prevent problems per
ANSI/SPRI/FM4435/ES-1
.
Lightning
protection systems for example must not be directly affixed to the product
provided by Hickman. Consult Hickman for alternative attachment
suggestions.
