1.
Set the function switch at A
~
position.
2.
Open the circuit in which the current is to be measured ,and
connect Test leads in series with the circuit and read LCD
display.
RESISTANCE MEASUREMENT
1.
Set the function switch at Ω position.(Note: The polarity of red
lead is po”)
2.
Connect test leads across the resistor to be measured and read
LCD display.
3.
If the resistor being measured is connected to a circuit, turn off
power of the circuit and discharge all capacitors before applying
test leads.
4.
When measuring resistance above 1MΩ,the meter will take a
few seconds to get stable reading .It is normal for high
resistance measurement.
DIODE TEST
1.
Set the function switch at
position.(Note: The polarity of red
lead is Po”)
2.
Connect the red test lead to the anode of the diode to be tested
and the Black lead to the cathode of the diode.
3.
The approx. forward voltage drop of the diode will be
displayed .If the Connection is reversed; only figure “OL” will
