SENSORS
All specifications are subject to change. Contact MTS for specifications that are critical to
your application. Go to www.mtssensors.com for the latest support documentation.
Level Plus
®
Liquid-Level Sensors
M-Series
Model MG
Digital Output
Transmitter Electronics Replacement Guide
551104 A
Contents
Guide overview
Software and hardware requirements
Technical support and shipping information
Notices used in this guide
Related publications
Before you begin
Software installation and configuration; Modbus and DDA
Transmitter electronics replacement procedures
Installing current parameters
Guide overview
M-Series Model MG
digital transmitter
This guide contains software setup and digital component replace-
ment procedures for the MTS M-Series Model MG digital transmitter
(gauge). Software setup screens shown in this guide are Modbus
examples. If you are installing DDA setup software, your setup screens
will be similar.
Notices used in this guide
Related publications
Technical support and shipping information
Software and hardware requirements
The M-Series transmitter design is modular in nature. The electronics
can be replaced in the field without on-site support of the MTS Service
Department.
Ordering information and software updates:
You can get the latest ordering information and software updates by
using the World Wide Web. Go to www.mtssensors.com.
Technical support
Phone: 800-633-7609
E-mail: levelplus@mts.com
Shipping address
MTS Systems Corporation
Sensors Division
3001 Sheldon Drive
Cary, North Carolina 27513
Notes
These notices provide important tips, guidance, or advice.
Caution
These notices indicate situations that can be potentially hazardous to
you. A Caution notice is placed just before a description of a potentially
hazardous procedure, step, or situation.
Attention
These notices indicate possible damage to devices or data. An
Attention notice is placed before the instruction or situation in which
damage could occur.
Always follow applicable local and national electrical codes and
observe polarity when making electrical connections. Do not remove
cover or make electrical connections to the M-Series transmitter with
power turned on. Make sure that no wire strands are loose or sticking
out of the terminal block connection which could short and cause a
problem.
The following publications are available in Adobe Acrobat Portable
Document Format (PDF) at http://www.mtssensors.com.
550731
- Installation sheet, M-Series Electronics Module
550784
- Product Specification, Level Plus M-Series Digital
550537
- Product Specification, Level Plus M-Series Floats and
Accessories
MTS Part Numbers:
625051
- M-Series PC Setup Modbus Software CD and RS-485 to
RS-232 Adapter
625052
- M-Series Digital PC Setup Modbus Software CD
380075
- RS-485 to RS-232 Adapter
625053
- M-Series Digital PC Setup (DDA)
