- 33 -
#7
The reader will stop reading if it cannot decode successfully within the
decode timeout (default is 5 sec).
#8
After reading, remove the symbol from the field of view.
#9
When the reader detects the object goes out from the field of view, the
reader goes back to #1. It is the same when the reader detects absence of
the object within the detection ignored time (default is 0.5 second). In case
the object goes out while reading or is left in the field of view after reading,
the reader stops reading when the decode timeout is passed (#7).
3.7.2 In case the reader cannot read symbols in Autosense Mode.
Please remove the object from the field of view and wait until the pointer starts
blinking, and then place it in again (step #1 in section 3.7.1).
3.7.3 Serial command
Please refer to section 7.3 Symbol Reading for the serial commands related to
Autosense Mode.
3.7.4 Enable/Disable Autosense Mode
Enable
:
SYNCMODE=3
Disable : SYNCMODE=0 or 1 or 2
3.7.5 Detection ignored time
[LFMOVELIM]
In case the object remains at the position beyond the time limit after reading, the
reader will handle as the object goes out from the field of view and start next
reading.
If the time limit is set short, please remove the object from the field of view
immediately. If the reader takes long time to remove it due to large object size,
please set the time limit longer.
Summary of Contents for TFIR-31LAN series
