- 65 -
6.4 Check for LAN settings
6.4.1
Through RS232C interface
Confirm the LAN settings by the command below.
The following parameters are sent to the host:
- IP address
- Sub net mask
- Default Gateway
- Port number
6.4.2 Through LAN interface
Communication state can be checked by UDP (User Datagram Protocol), if the
network address is already known.
1. Set IP address of the host into the same network as the reader.
2. Set the UDP settings.
* Remote IP address (TFIR-31LAN) for broadcasting.
e.g.) If remote IP address is “192.168.209.255”, all TFIR-31LAN units
will respond which IP address is “192.168.209.xxx”.
* Port number is always 49460
Confirm the settings by the command below.
The following parameters are output in a line:
- Local IP address (IP address of TFIR-31LAN)
- Local port number (Port number of TCP/IP server of TFIR-31LAN)
- Sub net mask
- Gateway IP address
- MAC address (last 3 bytes)
?who
?LAN
Summary of Contents for TFIR-31LAN series
