User's Manual
MS3713
Slim Plug-In Square-Root Extractor with Isolated Single/Dual Output
Rev. 1.40
4
10. Adjustment
Since the unit is precisely factory-adjusted before shipment, no
further adjustment is needed at the user’s side. Adjustment of signal
conditioners requires technical expertise and fine craftsmanship. We
recommend that you use adjustment service of MTT to save costs
and ensure accuracy. Please contact MTT or its local
representatives. Just for your reference, the adjustment procedure
is described below.
10-1. Preparation
For the terminal assignments, refer to section 5.
The wiring work should be performed with no power applied to
the instrument.
Wiring should be connected to the terminal block.
At least 30 minutes of warm-up is required before adjustment.
The accuracy of measuring equipment to be used for calibration
must be much higher than that of the instrument to be adjusted.
Since the ZERO and SPAN Trimmers work on both the output 1
and output 2, adjustment should be performed on the output 1.
(Adjustment of the output 1 has the same effect on the output 2.)
10-2. Adjustment Procedure
(1) Connect the unit as illustrated below.
(2) Adjust the voltage or current source to generate a signal
equivalent to 1% of the input range of the unit.
(3) Slowly turn the ZERO Trimmer to get 10% output while applying
1% input as above.
(4) Adjust the voltage or current source to generate a signal
equivalent to 100% of the input range of the unit.
(5) Slowly turn the SPAN Trimmer to get 100% output while
applying 100% input as above.
(6) Repeat steps (2) through (5) until zero and span are precisely
adjusted.
(7) Adjust the voltage or current source to generate 25%, 50% and
75% of the input signal range of the unit and record the values
of output signals to confirm they are linearly proportional.
CALIBRATED
ADJUSTABLE
VOLTAGE/CURRENT
SOURCE
MULTIMETER
POWER SUPPLY
11. Maintenance and Inspection
Check the unit for proper characteristics and settings about once
every two years.
12. Warranty Period and Scope
[Warranty Period]
MTT’s hardware products are warranted for a period of seven (7)
years from the date of shipment.
[Warranty Scope]
1) MTT warrants that its hardware products are free from defects
in materials and workmanship and conform to its product
specifications.
2) MTT ships the products under its appropriate quality
management system and quality control, but does not warrant,
expressed or implied, that the operation, output, or indication
of the hardware will be uninterrupted or error free. MTT shall
not be liable and make no warranty for any damage to or any
safety or performance trouble in the customer’s or any other
third party’s equipment if the operation, output, or indication is
interrupted or faulty.
3) If, during the warranty period, the product proves to be
defective when used in accordance with the relevant user’s
manual, the product will be repaired or replaced.
4) This warranty does not apply to any malfunction or failure
resulting from the following:
a. Improper or incomplete maintenance or calibration,
b. Any other cause, which does not relate with the delivered
product,
c. Modification or repair by any person other than MTT, and
d. Natural disasters or other unavoidable accidents, for which
MTT is not liable.
